![]() ![]() You should replace the battery within a few days. Congratulations after finishing all the steps your Classic Load Balancer is ready to use.So, you either had a system that was working and then a red light showed up, or you bought a used PLC and the fault light showed up. After finishing all these steps choose Review and Create. In the next step after registering EC2, you can optionally Tag your load balancer. attaché the EC2 instances and proceed further. In the next step, you need to add the EC2 instances on which you need to apply load balancing. AWS classic load balancer checks the health of ec2 instances using this pingpath. so in the ping path mention home page path of the ec2 webserver. Here port 80 represents the your ec2 instance webserver port and ping path represents home path of your website like index.html. s elect the ping protocol as shown in the image below. Here you can mention the health check path for the application you are using Load balancer. If you select a subnet from an Availability Zone where there is already an selected subnet, this subnet replaces the currently selected subnet for the Availability Zone.Ĭonfigure Health Check of backend ec2 instances.Īfter completing the previous step, you can click on Next: Configure Security Settings and proceed further. ![]() You can attaché at most one subnet per Availability Zone. To improve the availability of your load balancer, select all your subnets which are located in different availability zones. leave the listener as it is.įurther, you can select the available subnet which you have created. Configure the load balancerīy clicking on the classic LB, you will land onto another page where you can name the LB of your choice and select the same vpc where you lunched your ec2 instances. Then, choose the Classic Load balancer from the 3 options. In the left side of the panel choose the option Load Balancer. Go to the EC2 service in the desired region you wanted to deploy the classic load balancer. Alongside EC2 make sure you have vpc and the security groups are in place as per requirements. the first step is make sure that you have two or more than two Instances running in the same region where you want to deploy classic LB. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |